top of page
sun visor flipped down

step 1

Flip your sun visor down, unhook it, and pull it 2"-3" towards you.

SUN-SLIDE hanging over visor

step 2

Place the SUN-SLIDE over the end of your sun visor with the logo facing you. Push it toward the middle.

hands creasing SUN-SLIDE

step 3

With the logo at the center height level, squeeze firmly along the scores near the top and bottom edges, conforming the SUN-SLIDE to your visor.

SUN-SLIDE rear

step 4

Flip the sun visor over to the side. The two tabs should be exposed. Find the insertion slits that work best for a snug fit.

inserting tabs into slots

step 5

Pull the SUN-SLIDE off your sun visor. Carefully insert the two tabs into the best-fitting pair of insertion slits.

hands sliding SUN-SLIDE toward end of visor

step 6

Slip the SUN-SLIDE back on. Test the fit by gliding it between the center of the sun visor and beyond the open end.

SUN-SLIDE installed on both sun visors

step 7

You're all set!

SUN-SLIDES will effortlessly block side glare from both directions.

 

Enjoy the ride!

VISUAL INSTALLATION GUIDES

Follow the video or step-by-step images.

Setup time: Approximately 5mn per SUN-SLIDE.

bottom of page